The BIOS paused for while as it rebooted but then moved as normal.
Update Server address webdownloads.ts.fujitsu
I decided to try this out and set the options on the screen: I had noticed that in the BIOS, under the 'Advanced' tab there was an option for I tried to boot this I ended up with a just a flashing cursor in the top-left of the screen.Īfter a few minutes of poking around I gave up and moved on to the next option. It, and it copied over the Windows System to the S720's 16GB mSATA SSD. StickWizz to create a bootable USB pen drive. I downloaded the WS7P Recovery USB Flash Medium, unzipped the file and used (The SSD was blank having been wiped by the vendor of my S720).
Than seeing if I could unpick things I decided to download and install the latest version Whilst I managed to get the WS7P OS installed on the onboard mSATA SSD itĬhecking on the Fujitsu support site it looked like the only BIOS updates I found wereĪll rolled up into a WinFlash Application that ran within Windows. Plug the USB flash medium into an USB 3.0 Port of your FUTRO Thin Client To create a bootable recovery USB flash medium. Please extract this downloaded ZIP-file and execute StickWizz.exe Recovery for 8GB, 16GB and 32GB mSata or 16GB NAND flash. Mentioned Windows Embedded Standard (WS7P).ĭevice that was originally ordered and delivered with WS7P. This prompted me to check further on the back of my S720 where there was a (very) small label that (COA Label) attached to the device located on the back side of the housing If you are not sure please check this on the Microsoft license sticker
This Software may only be used for Recovery of a single Fujitsu FUTRO OEMĭevice that was originally ordered and delivered with Windows 10 IoT. Note: Each option has a file with the following information:
which resolved the problem of the version number of the current BIOS. However, having booted a copy of Tiny Core Linux, when I checked the boot message file I found the line:įUJITSU FUTRO S720/D3313-B1, BIOS V4.6.5.4 R1.16.0 for D3313-B1x Whilst, on going to the Fujitsu support site, I found the latest version to be 'V4.6.5.4 - R1.18.0 ()'. Initially I was a bit confused as, on the 'Main' screen it showed This describes itself as the Aptio Setup Utility. Hit F2 at power-on to get into the AMI BIOS.